Edit Color dialog

The Edit Color dialog enables you to edit and measure colors and edit output tool paths.

General tab

RGB values	Use the slider to control values or enter a number.
Measure	Select a spectrophotometer (color must be named).
Color type
Reflectivity
Color name
Vendor
Vendor code
Pen

Output Tool Paths tab

EngraveLab

RGB values	Use the slider to control values or enter a number.
Measure	Select a spectrophotometer (color must be named).
Pen
Depth
Depth per pass
Last pass depth
Passes

 

Laser L Edition

RGB values	Use the slider to control values or enter a number.
Measure	Select a spectrophotometer (color must be named).
Materials
Mode	Note: When creating drill point tool paths, Hole mode must be assigned.
Speed
Power
Passes
Bi-Dir	Select for bidirectional output applicable only to raster work modes. When enabled, laser sweeps in both directions.
Output as one object
Scan Gap	Set the number of lines to output per selected measurement unit (inch or mm).

Ruida Edition

Note: Options depend on selected mode.

Materials
Mode	Note: When creating drill point tool paths, Hole mode must be assigned.
Speed
Passes
Blower	While: When the machine is running. Always: Always on.
Bi-Dir	Bi-directional
Scan Gap	The distance the laser moves vertically between passes.
Hole in Center
Hole Interval
Hole Length
L1, L2
Min Power
Max Power
Laser Through Mode	Select for multiple cuts and set Through Power.
Through Power	The power of the laser in Through Mode. Note: Laser Through Mode must be selected and Open Delay cannot be 0.
Grade Width
Radiation Time
Open Delay	Delays the start of the laser.
Close Delay	Delays when the laser stops after the cut.