User Settings dialog
Utilice la tabla para la configuración
Cut (Vector) | |
Cut Parameter Presets | Select a preset. |
Idle Speed | The speed of the head when the laser is not active. |
Minimum Acceleration | The minimum acceleration speed. |
Idle Acceleration | The acceleration speed of the head when the laser is not active. |
Start Speed | The acceleration from stop to cutting speed. |
Maximum Acceleration | The maximum acceleration speed. |
Idle Delay | Delay from rest to movement. |
Acceleration Factor | Set a global acceleration to apply to other settings. |
Go Acceleration | Boundary cutting speed. |
Speed Factor | Set a global speed to apply to turning corners. |
Sweep (Raster engrave) | |
X Start speed | |
Y Start speed | |
X acceleration | |
Y acceleration | |
Line shift speed | The maximum speed for scanning to shift lines. |
Facula size | The laser dot size. |
Engraving factor | The speed of engraving on a scan layer. |
Scan mode |
In Special mode, the laser fires at higher power for shorter durations. Note: Common mode is recommended. |
Table | Adjust speed, backlash, and offset. |
Sweep (3D) | |
Table | Adjust speed, backlash, and offset. |
Feeding | |
Delay before feed | |
Delay after feed | |
Progress feeding repay | Used in case of an error in the feed rate. |
Progress feeding | |
Last feeding | |
Home | |
Home speed | The speed at which the head returns to home position. |
Auto home X | Automatically move the laser head to home on start up. |
Auto home Y | |
Auto home U | |
Auto home Z | |
G0 scale | |
G0 scale blank | The frame is based on the image and a space is added to the side of the border to graphics are contained. |
G0 scale mode | The laser fires around the border. |
Other | |
Focus depth | Set a depth for auto focus |
Backlash X, Y | Set to compensate for backlash. |
Array processing | Select a direction. |
Return position | Set the machine origin. |
Rotating | |
Circle pulse | The number of pulses to turn 360 degrees. |
Diameter | Material diameter. |
Test speed | |
Enable rotating |