Edit Color dialog
The Edit Color dialog enables you to edit and measure colors and edit output tool paths.
Onglet Général
RGB values | Use the slider to control values or enter a number. |
Measure | Select a spectrophotometer (color must be named). |
Color type | |
Reflectivity | |
Color name | |
Vendor | |
Vendor code | |
Pen |
Output Tool Paths tab
EngraveLab
RGB values | Use the slider to control values or enter a number. |
Measure | Select a spectrophotometer (color must be named). |
Pen | |
Profondeur | |
Profondeur par passe | |
Profondeur dernière passe | |
Passes |
Laser L Edition
RGB values | Use the slider to control values or enter a number. |
Measure | Select a spectrophotometer (color must be named). |
Materials | |
Mode | Note: When creating drill point tool paths, Hole mode must be assigned. |
Speed | |
Power | |
Passes | |
Bi-Dir | Select for bidirectional output applicable only to raster work modes. When enabled, laser sweeps in both directions. |
Output as one object | |
Scan Gap | Set the number of lines to output per selected measurement unit (inch or mm). |
Ruida Edition
Note: Options depend on selected mode.
Materials | |
Mode | Note: When creating drill point tool paths, Hole mode must be assigned. |
Speed | |
Passes | |
Blower |
While: When the machine is running. Always: Always on. |
Bi-Dir | Bi-directional |
Scan Gap |
The distance the laser moves vertically between passes. |
Hole in Center | |
Hole Interval | |
Hole Length | |
L1, L2 | |
Min Power | |
Max Power | |
Laser Through Mode | Select for multiple cuts and set Through Power. |
Through Power |
The power of the laser in Through Mode. Note: Laser Through Mode must be selected and Open Delay cannot be 0. |
Grade Width | |
Radiation Time | |
Open Delay | Delays the start of the laser. |
Close Delay | Delays when the laser stops after the cut. |