Queue tab

The Queue tab controls apply to the current queue. Use the drop-downs to make selections about media type, size, and layouts.

Set the print quality, paper, direction, carriage width, pass delay, white passes, queue margins, etc.
Note: Options vary by device.

Click Substrate Color to set the substrate color of the queue.
Note: Ensure no jobs are selected, or the color will be set per job.

To add new media or configure added media, click the ellipsis ()button. The Media Setup dialog appears. Depending on the media, you may see the Media Setup dialog or the Template Setup dialog.

• Enter a name, size, and margins.

To configure template media, click the ellipsis button () next to the template drop-down. The Template Setup dialog appears (unless you are using a default template). See Template Setup dialog.

In the Template properties section, enter a name and specify the dimensions, or select a sheet as a base.

In the Slot configuration section, specify the size of a slot (the expected size of a placed job).
Note: Define the alignment, scaling, and rotate settings prior to creating copies so changes are applied universally.

Color Adjust

To adjust Queue color, click to open the Easy Color Adjustments dialog. Available options are device dependent.

Color Adjust

• Use the sliders to control lightness and darkness for hues, ink levels, brightness, saturation, and chroma.
• Select ICC Setting, Photo, or Graphics.

Processing Options

• When a white channel is available, set the maximum white ink %, choke, and strength.
• Set the highlight strength and switch layers (if applicable) to set the maximum ink coverage for the underbase, the choke (to limit the spread of the primer layer), and the strength.
• When a clear channel is available, set the maximum clear ink % and spread.